自動攪拌車出現故障的快速排除法!
概述: 自動攪拌車若是出現故障的話,那么不是會對車輛本身造成危害,更重要的是攪拌車內的混凝土也會受到波及,若是混凝土因?yàn)樽詣?dòng)攪拌車的故
自動攪拌車若是出現故障的話,那么不是會對車輛本身造成危害,更重要的是攪拌車內的混凝土也會受到波及,若是混凝土因?yàn)樽詣?dòng)攪拌車的故障而凝固了的話,那么將會造成非常的損失,所以為了避免這種情況的發生,當發現自動攪拌車有故障發生的時候,應當及時找出故障點進行。
If the automatic mixer truck breaks down, it will not cause harm to the vehicle itself, but more importantly, the concrete in the mixer truck will also be affected. If the concrete solidifies due to the failure of the automatic mixer, it will cause extraordinary losses. Therefore, in order to avoid this situation, when it is found that the automatic mixer has a fault, it should Find out the fault point and solve it in time.
一、罐體轉動工作原理
1、 Working principle of can body rotation
發動機取力器——傳動軸——油泵——馬達——減速機——罐體轉動
Engine power take-off - transmission shaft - oil pump - motor - reducer - can body rotation
二、原因分析
2、 Cause analysis
導致自動攪拌車攪拌罐停轉主要有以下原因:
The main reasons for stopping the mixing tank of the automatic mixer are as follows:
1.發動機故障:發動機無法啟動、取力器損壞等原因。
1. Engine failure: the engine can not be started and the power take-off is damaged.
2.上裝故障:傳動軸損壞、油泵故障、液壓油過臟或油量不足、馬達故障、減速機故障、操縱桿松脫等原因。
2. Upper mounting fault: transmission shaft damage, oil pump failure, hydraulic oil too dirty or insufficient, motor failure, reducer failure, control rod loose and other reasons.
以上是關于自動攪拌車出現故障快速排除法的相關介紹,很實用的,您肯定可以用到!
The above is about the automatic mixer truck troubleshooting related introduction, very practical, you can certainly use!