概述：攪拌一體車是工程建造中必不可少的設備，但是由于是自動設置，使用時間長后部分功能會影響整體使用，下面跟著小編了解下攪拌一體車使用期間
攪拌一體車是工程建造中必不可少的設備，但是由于是自動設置，使用時間長后部分功能會影響整體使用，下面跟著小編了解下攪拌一體車使用期間這些弊端要避免吧。
The all-in-one mixer is an indispensable equipment in engineering construction. However, due to its automatic setting, some functions will affect the overall use after a long time of use. Let's follow the small compilation to understand that these drawbacks should be avoided during the use of the all-in-one mixer.
一是齒輪箱的正常壓力范圍為1.08~1.47MPa，壓力低于1.08MPa。認為變速油壓太低，這將導致攪拌一體車的驅動力不足，整機弱，齒輪不起動。減壓閥的功能是通過壓力調節彈簧將較高的輸入壓力調節到規定的輸出壓力，并確保輸出壓力的平衡。一旦減壓閥的壓力調節彈簧損壞，變速箱將不能保證正常的輸出壓力。
First, the normal pressure range of the gearbox is 1.08~1.47MPa, and the pressure is lower than 1.08MPa. It is believed that the speed change oil pressure is too low, which will lead to insufficient driving force of the mixer, weak whole machine and gear failure to start. The function of the pressure reducing valve is to regulate the higher input pressure to the specified output pressure through the pressure regulating spring, and ensure the balance of the output pressure. Once the pressure regulating spring of the pressure reducing valve is damaged, the transmission will not be able to guarantee the normal output pressure.
二是壓力調節器沒有適當調整。壓力調節閥通過壓力調節閥芯控制變速器的輸出壓力。如果輸出壓力太小，變速箱油壓將太低。
Second, the pressure regulator was not properly adjusted. The pressure regulating valve controls the output pressure of the transmission through the pressure regulating valve core. If the output pressure is too low, the transmission oil pressure will be too low.
三是管道油封嚴重漏油。檢查變速箱油盤到變速箱泵吸入管路是否泄漏。如果發現漏油，請修理或更換新線路。
Third, the oil seal of the pipeline leaks seriously. Check the transmission oil pan to the transmission pump suction line for leaks. If oil leakage is found, repair or replace the circuit.
車輛保養方面：
Vehicle maintenance:
1、要定期更換機油，液壓油。
1. Change the oil and hydraulic oil regularly.
2、車輛底盤的保養周期要嚴格履行，有些廠家如果客戶沒有嚴格履行，或者在其他修理廠更換了零部件，后來造成車輛損失的，是不予索賠的。
2. The maintenance cycle of the vehicle chassis should be strictly followed. Some manufacturers will not claim for damages if the customer does not strictly follow the maintenance cycle, or if they replace parts in other repair shops.
3、每天用完車都要仔細清洗罐體外表，內腔，否則混凝土凝結以后你的車裝料會越裝越少的。
3. Carefully clean the outer surface and inner cavity of the tank after using the car every day, otherwise your car will be less and less loaded after the concrete is set.
除了清洗殘余料，還要把車輛比如托輪、輥道之類的地方清理干凈，常常會有石子殘留，日積月累會降低你的鋼結構正常使用壽命。所以說在了解好攪拌車的使用要點，還要對其進行定期的維護，更多相關內容就來我們網站
http://www.fxsgujg.cn咨詢吧！
In addition to cleaning the residual materials, you should also clean the vehicle, such as the supporting wheel and roller table. There are often stone residues, which will reduce the normal service life of your steel structure over time. Therefore, in order to understand the key points of using the mixer well, we should also carry out regular maintenance on it. More relevant information can be found on our website http://www.fxsgujg.cn Consult!
點擊撥打服務熱線：4008791999
