自動上料攪拌車一般在放料完成后，卸料部分會殘留許多混凝土，一般情況下用清水清理即可，可是遇到已經凝固在自動上料攪拌車上的情況下，我們該怎么辦？
Generally, after the automatic feeding mixer is completed, there will be a lot of concrete left in the unloading part, which can be cleaned with clean water under normal circumstances. But what should we do if it has solidified on the automatic feeding mixer?
自動上料攪拌車在完成方料后就應當進行清洗保養及維護，以免降低自動上料攪拌車的使用壽命，許多攪拌車司機們也知道這個道理，也經常對自動上料攪拌車卸料部分進行清理維護，但是有一個問題就是大家往往忽略的，就是用不好用不對清洗液也是會造成卸料部分損壞的。
The automatic feeding mixer should be cleaned, maintained and maintained after the completion of the square feeding, so as not to reduce the service life of the automatic feeding mixer. Many mixer drivers also know this truth, and often clean and maintain the unloading part of the automatic feeding mixer. However, one problem that is often overlooked is that the unloading part will be damaged even if the cleaning fluid is not used properly.
1、用好的清洗液，掌握正確的方法，適當用量，正確的使用標準可以參考清洗液的說明書，而且要適量，否則清洗液里面的化學成分會損壞自動上料攪拌車的相關結果。
1. Use a good cleaning solution, master the correct method, use the appropriate amount, and refer to the cleaning solution manual for the correct use standard, and use the appropriate amount, otherwise the chemical composition in the cleaning solution will damage the relevant results of the automatic feeding mixer.
2、選擇清洗液，一般用常見的堿性溶液，不要使用化學成分高的，濃度高的清洗產品。自動上料攪拌車在日常生活中是使用非常頻繁的，所以，清洗自動上料攪拌車也是相當重要的。
2. Choose cleaning solution, generally use common alkaline solution, and do not use cleaning products with high chemical composition and concentration. The automatic feeding mixer is used very frequently in daily life, so it is very important to clean the automatic feeding mixer.
此外托輪也要保養好，攪拌車的托輪要定期補加潤滑脂，托輪的表面要經常清理附著在上面的混凝土，然后注油，這樣可以避免托輪的磨損，延長使用壽命。
In addition, the supporting wheel should also be well maintained. The supporting wheel of the mixer truck should be regularly added with lubricating grease. The surface of the supporting wheel should be regularly cleaned of the concrete attached to it, and then filled with oil. This can avoid the wear of the supporting wheel and prolong its service life.
自動上料攪拌車的散熱器也是保養的，每天檢查散熱器的風扇是否正常運轉，對葉片上的灰塵及時清洗，散熱器的過濾芯要定期更換，濾芯精度要與原裝濾芯保持一致。
The radiator of the automatic feeding mixer is also the focus of maintenance. Check whether the radiator fan operates normally every day, clean the dust on the blade in time, replace the filter element of the radiator regularly, and keep the accuracy of the filter element consistent with the original filter element.
液壓泵的保養，液壓油須保證清潔，平時一定要避免泥沙污水進入液壓油內，一旦發現液壓油和液壓零部件上有污水泥沙，就立刻清洗并更換液壓油。更多相關內容就來我們網站
http://www.fxsgujg.cn咨詢吧！
For the maintenance of hydraulic pump, the hydraulic oil must be kept clean, and sediment and sewage must be avoided from entering the hydraulic oil at ordinary times. Once sewage and sediment are found on the hydraulic oil and hydraulic parts, the hydraulic oil shall be cleaned and replaced immediately. More relevant content will come to our website http://www.fxsgujg.cn Consult!
點擊撥打服務熱線：4008791999
