欧美成人午夜在线播放-成人午夜视频欧美-情欲毛片亚洲一区二区-日本亚洲欧美综合在线-欧美亚洲日本va

　　When using the automatic feeding mixer, there will be noise. What are the reasons for the noise? How should we deal with it?

　　1、罐體內有粘結的混凝土存料：要清鏟干凈。

　　1. The concrete with bond in the tank body shall be cleaned.

　　2、吸油管路進氣或堵塞：檢查擰緊，不要吸進空氣。

　　2. Oil suction pipe air intake or blockage: check and tighten, do not suck in air.

　　3、泵的安裝支架的剛性不足，工作時會產生震動和噪音：加固支架。

　　3. The rigidity of the pump mounting bracket is insufficient, and vibration and noise will be produced when working: reinforcement support.

　　4、工作油液不合要求或油液粘度太大：更換低粘度的液壓油。

　　4. The working fluid does not meet the requirements or the oil viscosity is too high: replace the low viscosity hydraulic oil.
          

　　5、濾芯堵塞造成吸油困難或不足：清洗或更換濾芯。

　　5. Difficult or insufficient oil absorption due to blockage of filter element: clean or replace filter element.

　　6、油箱液面太低，油面上空氣被吸入泵內：補加相同標號的液壓油。

　　6. The oil tank level is too low, the air on the oil surface is sucked into the pump: add the same label of hydraulic oil.

　　7、輸入法蘭與萬向傳動軸的連接、萬向傳動軸與取力器的連接角度過大、松動時會產生噪音：檢查緊固。

　　7. If the connection angle between input flange and universal drive shaft and the connection angle between universal drive shaft and power take-off is too large, noise will be generated when it is loose: check fastening.

　　自動上料攪拌車的工作環境是非常惡劣的，所以在使用的時候會出現一些問題也是不可避免的，今天我們?yōu)榇蠹抑v解了出現噪音的原因以及方法，這樣大家要是碰上了問題可以進行。如您還有其他問題歡迎咨詢自動上料攪拌車http://www.fxsgujg.cn官網。

　　The working environment of the automatic feeding mixer is very bad, so it is inevitable that some problems will appear when using it. Today we explain the causes of the noise and the solutions, so that if you encounter problems, you can solve them. If you have other questions, please consult the automatic feeding mixer http://www.fxsgujg.cn Official website.